- Veteran Owned & Operated
- Serving Kansas City Metro
- 24/7 Emergency Service
- Call Now: (816) 317-0061
Veteran Electric covers more ground than just Platte City. If you’re just outside town, we also serve Smithville, Gladstone, Plattsburg, and Kansas City.
Don’t see your town listed? We most likely still cover it. See our full Kansas City metro service area or call (816) 317-0061 and we’ll tell you straight.
A panel upgrade starts with a load calculation: our electrician walks the house, counts the circuits already in use, and adds up what a generator, an EV charger, or a couple of larger appliances would pull if installed later. From there we pull the permit, arrange for Evergy or the utility to disconnect service for the swap, and remove the old panel. The new panel goes in with breakers sized to each circuit, everything labeled, and the grounding and bonding checked against current code. Once the wiring is reconnected and the service is restored, a local inspector signs off before we close up the wall. Most homeowners can expect a short outage while the swap happens, with the paperwork and inspection handled on our end.
Platte City sits in Platte County, Missouri, which is one of several jurisdictions across the Kansas City metro along with Clay and Jackson counties on the Missouri side, and separate authorities across the state line in Kansas. Each city and county has its own building department that pulls the permit and sends an inspector to sign off on panel upgrades, generator installs, and new circuits, so the authority having jurisdiction can change block by block near a city line. Utility coordination usually means working with Evergy for the disconnect and reconnect on a panel swap or generator hookup. A lot of the housing stock around Platte City dates back decades, so older wiring and undersized panels come up often on residential calls.
Yes, we install home standby generators for Platte City properties, sizing the unit to the electrical load of the house before anything goes in the ground or on a pad. Our electrician handles the transfer switch wiring so the generator takes over automatically when Evergy power drops, and we coordinate the gas or propane hookup with the fuel provider. The transfer switch is set up to keep the generator circuit isolated from the utility line for safety.
An electrical panel upgrade replaces an undersized or outdated panel with one rated for the home’s actual electrical load. We start by counting the circuits already on the panel and what the homeowner plans to add, such as a generator or an EV charger, then size the new panel accordingly. Older Platte City homes often still have fuse boxes or panels that were never built for today’s appliance load, so this is one of our most common calls.
Yes, EV charger installation is a routine job for us in Platte City, whether it is a garage wall mount or a driveway pedestal. We check the panel’s available capacity first, since a charger needs its own dedicated circuit sized to the vehicle’s charging rate. If the existing panel does not have room, we can pair the charger install with a panel upgrade.
Yes, our electricians in Platte City are licensed for residential electrical work, from new construction wiring to repairs in older homes. Every job is treated the same whether it is a single outlet repair or a full panel replacement. We also handle commercial maintenance for Platte City businesses.
Yes, Veteran Electric works as an electrical contractor for both residential and commercial projects in Platte City. Commercial jobs typically involve coordinating around a business’s operating hours so work does not interrupt customers or staff. Request a free estimate and we can scope the job before anything is scheduled.
