Home rewiring in Lee’s Summit often starts with the age of the house. About 7 percent of the city’s 42,240 housing units, or 2,864 homes, were built before 1960, and about 25 percent were built before 1980. Wiring from those decades was designed for fewer lights, fewer outlets and far lighter electrical demand than a household uses now. Veteran Electric KC is a veteran-owned and operated licensed electrician, and we rewire homes with care, replacing worn circuits with new copper wiring and leaving your finished rooms as intact as the work allows.
Whole house rewiring in Lee’s Summit does not have to mean opening every wall. Every job starts with a free estimate, and the price is given to you in writing before work begins. We inspect your attic, crawlspace and electrical panel, explain what we find, and tell you plainly whether a full rewire or a smaller repair fits the house. When the work is done, we handle the permit and book the inspection, so the paperwork is not left to you. Call (816) 317-0061 to set up a walkthrough.
These signs in an older house usually point toward new circuits instead of another patch.
A full rewire begins with a close look at how the house is wired today. We trace the circuits, check the panel, and mark which runs can stay and which should be replaced. New copper cable is then routed through attics, crawlspaces and wall cavities from the most accessible points, so plaster and finished drywall are disturbed as little as possible. A few small access openings are sometimes needed, and we patch them. Every outlet, switch and fixture is tested before the inspection.
Old house rewiring in Lee’s Summit often involves the panel too. Older homes may still have a fuse box or an undersized panel, and we install 100, 200 and 400 amp services, with 200 amp recommended for most homes. When the service is replaced, the meter disconnect and reconnect is coordinated with your utility. Electrical rewiring in Lee’s Summit also pairs well with a hardwired whole-home surge protector at the panel, typically rated 50kA to 80kA, to protect the new circuits.


We examine the panel, attic, crawlspace and visible wiring to find knob and tube, aluminum or ungrounded cloth-covered circuits.

You get a free written price, then we sequence the work room by room and arrange the permit.

New copper circuits are run through the framing, and outlets, switches and boxes are replaced as each circuit is connected.

We test every circuit, patch the access openings, and book the final inspection with the local building authority.
Lee’s Summit has a wide mix of housing ages. Half of the city’s homes were built in 1994 or earlier (the median year built is 1994), and 1,311 homes were built in 1939 or earlier, about 3 percent of the housing stock. Homes from the oldest group are where knob and tube wiring replacement in Lee’s Summit is most likely to apply. The city also covers about 63.9 square miles of land, the largest of the towns we serve outside Kansas City, so we confirm the address and scope with you before scheduling a walkthrough.
Codes matter on a rewire. Lee’s Summit adopted the 2024 International Codes and the 2023 National Electrical Code, effective October 1, 2026, and projects submitted before that date are reviewed under the 2018 codes and the 2017 NEC. Under the 2023 code, section 230.67 requires a surge-protective device on a dwelling’s service, including when the service is replaced. About 25 percent of occupied homes in the city heat with electricity as their main fuel, which makes a sound, properly sized electrical system worth the attention. We pull the permit and sort out which code applies to your project.
See the same rewiring service in other towns close to Lee’s Summit.
For the full picture, see our metro wide page or the Lee’s Summit town page.
Explore our other electrical services available in Lee’s Summit.
Run a business or manage a building in Lee’s Summit? These pages cover our commercial work there.
Neither is always cheaper. Replacing only the failing circuits costs less up front when the rest of the wiring is grounded and in good shape. If the house has widespread cloth, aluminum or knob and tube wiring, doing it in pieces can mean repeated visits and repeated patching. We look at the whole system during the free estimate and give you the price in writing.
Veteran Electric KC does. We are a licensed and insured Missouri electrician, and we replace knob and tube circuits with new grounded copper wiring, pull the permit and book the inspection. Because knob and tube has no ground wire, we also check the panel and the devices on each circuit, so the finished system works as a whole.
Yes. Rewiring is permitted and inspected work, and we take care of that paperwork for you from start to finish. Which code edition governs your project depends on when it is submitted: Lee’s Summit moved to the 2023 National Electrical Code effective October 1, 2026, while earlier submissions are reviewed under the 2017 NEC. We confirm which one applies before any work begins, so there are no surprises at inspection.
Not always. We check the panel during your estimate and tell you plainly whether it can stay. Homes with an older fuse box or a panel without room for new circuits usually need an upgrade, and 200 amp service is recommended for most homes. If the service is replaced, the 2023 code calls for a surge-protective device, which we hardwire at the panel.
Usually not. We route new cable through attics, crawlspaces and wall cavities wherever access allows, and open small sections only where needed, then patch them. Plaster walls and finished ceilings take more planning, so we point out likely access spots at the estimate. We also talk through timing and whether you can stay home during the work.