An electrical panel upgrade in Lawson usually starts with the age of the house. Half of Lawson’s homes were built in 1979 or earlier, with a median year built of 1979. Panels and service sizes from that era were planned around fewer appliances than most families run today. Veteran Electric is a veteran-owned and operated licensed electrician, and we plan every panel job around what your home actually uses. We check the load, the service size and the condition of the equipment, then explain in plain terms what your home needs and what it does not.
Every job starts with a free estimate, and the price is given in writing before work begins. We pull the permit, book the inspection and coordinate the meter disconnect and reconnect with Ameren Missouri, so you do not have to chase any of it. Most panel upgrades are finished in a single day. If you are comparing options, this page covers when a panel needs attention, how service sizes differ and what the job looks like from the first visit to the final inspection.
These are the common reasons homeowners call us about their panel.
Most homes do well with a 200 amp service, and that is the size we recommend for most houses. It carries central air, an electric range or dryer and an EV charger without strain, and it leaves room for what comes next. A 100 amp service can still work in a smaller home with gas appliances and modest demand, but it leaves little spare capacity. We install 100, 200 and 400 amp services, and 400 amp suits a very large house or one with heavy electric loads such as several chargers or workshop equipment.
If you are planning a 200 amp service upgrade in Lawson, we start by working out your home’s load and inspecting the incoming service, the grounding and where the panel is mounted, so the size we propose fits how you live. Where grounding or bonding falls short, we correct it to meet current code. Whole-home surge protection can be hardwired at the panel as part of the job, typically rated 50kA to 80kA, and it covers every circuit in the house.


We calculate the load, look over the service, grounding and panel location, and give you a free written estimate before any work begins.

We pull the permit and arrange the meter disconnect and reconnect with Ameren Missouri so the schedule is set before we arrive.

We remove the old equipment, mount the new panel and move each circuit over with clear labels, then test every circuit once power is on.

We book the inspection, and you get a labeled panel directory, with power fully restored once the work passes.
Lawson has about 2,905 residents, and about 72 percent of occupied homes are owner occupied. That matters for a panel, because the person paying for the work is usually the person living with it for years. About 53 percent of the town’s housing units were built before 1980, and about 18 percent of its 1,102 housing units (195 homes) were built before 1960. A home from those decades may still carry an older panel, a fuse box or a 100 amp service, so a quick look at the equipment is a sensible first step before you plan a renovation or add an appliance.
About 20 percent of occupied homes in Lawson heat with electricity as their main fuel, while about 79 percent of households heat with utility gas and about 1 percent with bottled or tank propane. Electric heat adds a large load to a service, so those homes get a careful calculation from us before we recommend a size. In November 2025, Ameren Missouri finished a substation upgrade serving the town, replacing a transformer that had been in service since the Eisenhower administration. We coordinate directly with Ameren Missouri for the meter disconnect and reconnect on every panel job.
We also handle panel upgrades for homeowners in nearby towns, and you can find those pages linked below.
For the full picture, see our metro wide page or the Lawson town page.
Beyond panels, we offer other residential electrical services in Lawson, linked below.
Run a business or manage a building in Lawson? These pages cover our commercial work there.
Common triggers are a fuse box, no open breaker slots, breakers that trip often, lights that dim when large appliances start, or a panel that runs warm or buzzes. A planned renovation, EV charger or electric heat can also call for more capacity. If you are unsure, we can inspect the panel and tell you plainly whether it needs work.
For most homes we recommend 200 amps, which covers central air, electric appliances and later additions such as an EV charger. A smaller home with gas appliances may do fine on 100 amps, but electric heat changes the math, and about 20 percent of occupied homes in Lawson heat with electricity. We calculate your actual load during the free estimate and recommend a size from that.
We do. Pulling the permit and booking the inspection are part of every job, and we coordinate the meter disconnect and reconnect with Ameren Missouri, the utility serving Lawson. You give us the go-ahead on the written estimate, and we handle the paperwork and scheduling from there. Call (816) 317-0061 to start your free estimate.
Most panel upgrades are finished in a single day. Power is off while the old panel comes out and the new one goes in, so plan around that. The meter disconnect and reconnect are coordinated with Ameren Missouri, and we book the inspection as part of the job. Your free written estimate lays out the scope before any work begins.
The count depends on the specific panel, since each model has its own number of breaker spaces. Some circuits take two spaces, such as those for ranges or dryers, so the space count is not the same as the circuit count. We check the panel’s spaces and your planned additions during the estimate, and we can size the new panel with room to spare.